| Can only be used on Samples and Synthsounds |
|
|
| Explanation |
| This command is used to add vibrato (harsher or deeper) to a given note. |
|
|
| What does it do? |
| This command is used to add colour to your music, not all notes in your song are just played as they are, getting this colour means performing little tricks to get different sounds and effects from that note. Vibrato is similair to a guitarist using a "whammy bar" to have the note played to "wobble", this effect is used to to take the flatness of the end of a note and give it a bit of excitement too. |
| The Command parameters: |
| Position Note Inst CMD Value 1 Value 2 |
 |
| All values are represented by HEX numbers, allowed parameters for both values 1a and 1b are from 0 to F |
| Value
1a: This
represents the speed of the vibrato, the lower the number the slower
the vibrato will be and the higher the number the quicker the
vibrato. Value 1b: This represents the amount of vibrato that will be added to the note. again the lower the number the less the vibrato as apposed to higher the number the greater amount of vibrato. |
| How to use |
| You can enter Command 03 by hand, but I believe that this command is easier dealt with the above method. If you use this method try incrementing value 1 in steps 2 or 3 (Depending on the BPM) to have the slide move up in semi-tones and then use value 2 to fine tune the speed |
| The Command 04 can be used in conjunction with Commands 06. |